V2100 Hard Hat® High Heat Aerosol Aluminum 425g
892.V2116838RUS
- UNSPSC 31211507
Clearance
Delivery
In stock delivery from our warehouses.
0 Review(s)
Log in to see customized pricing and stock availability
Units/package: 1 13 Pkg(s) Maximum Quantity:
Units/package: 1 13 Pkg(s) Maximum Quantity:
IN-STORE
(Live stock shown is only for our stores located in Ontario.)
Not stocked in Vaughan, ON.
Not stocked in Mississauga, ON.
Product Details
Attribute | Value |
---|---|
Contents | 425 g |
EAN | 4065746643191 |
Features
Withstands temperatures up to 537°C (1000°F) |
Tough, professional finish—superior resistance to chipping, cracking and peeling |
High-output tip covers 50% faster |
Dries 20% faster than other brands |
accepted for use in federally registered food facilities |
Applications
For maximum corrosion and heat protection. |
Instructions
Preparation: Remove all dirt, grease, oil, salt, and chemical contaminants. Scuff sanding may be required on very smooth surfaces ex. thoroughly cured, hard or gloss coatings to maximize adhesion. |
Application: Use when temperature is above 10°C (50°F) and humidity is below 85%. Surface temperature must be between 10-38°C (50-100°F). Protect surrounding surfaces from overspray. Do not use any primer. Shake can for one minute after mixing ball is heard. Hold can 10-14” from surface. Apply several light coats a few minutes apart to avoid drips and runs. |
Dry & recoat times: Recoat within one hour or after 24 hours. Allow more time in cooler temperatures. |
Clean-up: Wipe off tip before storing. Remove wet paint with xylene or mineral spirits. |
Clogging: If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening. |
Notices
Not for use on galvanized steel. |
This information is based on our experience. Preliminary tests are advised before use. |
Documents & Videos
Review(s)
Product not yet rated.